3M Tegaderm High Performance Foam Adhesive Dressing

How to use 3M Tegaderm High Performance Foam Dressing?

Before Using the 3M Foam Dressing

1. Clip excess hair for patient comfort.

2. Cleanse wound and surrounding skin according to facility policy.
   Note: If periwound skin is fragile or exposure to wound exudate is likely, apply a barrier film. Allow the barrier film to dry before dressing application.

3. Assess wound. Select appropriate size dressing to ensure that the foam pad is larger than the wound area.

Applying the Tegaderm Adhesive Dressing

1. Remove dressing from package.
2. Hold the dressing by one of the side tabs and remove the printed liner, exposing the adhesive border
3. While holding the tabs, position the dressing over the wound.
4. Gently press the adhesive film border to the skin. Avoid stretching the dressing or the skin.
5. Beginning at the center of the dressing, grasp one section of the paper carrier and pull toward the outer edge of the dressing. Repeat this for each of the remaining carrier sections until all paper carrier is removed. 
6. Firmly press and conform the adhesive border to the skin

Heel/Elbow Application

1. Remove dressing from package.

2. Hold the dressing by one of the side tabs and remove the printed liner, exposing the adhesive border.

3. While stabilizing the leg or surrounding tissue with one hand, position the dressing over the wound.

4. With one hand, press or “cup” the dressing onto the skin. Continue to press and conform the dressing and adhesive border onto the skin.

5. Beginning at the center of the dressing, grasp one section of the paper carrier and pull toward the outer edge of the dressing. Repeat this for each of the remaining carrier sections until all paper carrier is removed 

6. Firmly press and conform the adhesive border to the skin

Removing the 3M Foam Dressing

1. Carefully lift the dressing edges from the skin. If there is difficulty lifting the dressing, apply tape to the edge of the dressing and use the tape to lift.

2. Continue lifting the edges until all are free from the skin surface. Remove the dressing.

Considerations:

• Observe the dressing frequently. As the dressing absorbs, exudate will wick to the top of the dressing and discoloration may be noticeable. When the exudate spreads to the edges of the dressing or the dressing begins to leak, a dressing change is indicated

• 3M Tegaderm High Performance Foam Adhesive Dressing may be used as an absorbent cover dressing over wound fillers such as alginates or gauze packing

• Dressing change frequency will depend on the type of wound,volume of exudate and clinical situation. Change at least every seven days or as indicated per treatment protocol

• You may cut the dressing as needed to fit the size of the wound or accommodate wound contours. Seal the cut edge with 3M Tegaderm Transparent Dressing to provide waterproof barrier

For best results, store at room temperature. Avoid excessive heat and humidity. For shelf life, refer to the expiration date printed on each box

Customer Reviews

Questions & Answers

Ask a Question

Enter your question below:

Enter your Name   Enter your Email Enter your Email

Security question 5+ 4 = Enter sum of numbers   Submit Cancel

Enter your Answer below.

Ans

Enter Your Name Enter Your Email

Security Question: 5 + 4 = Enter sum of numbers

	ItemQuestion ItemName - now
	Your question will show here once it will get approved.

	UserAnswer UserName - now Your Answer will show here once it will get approved.